Follow us :

Saintyol DAWIN Machinery shares four maintenance skills for concrete mixing pumps

sourceSaintyol DAWIN News Center

publisherJenny

time2022/09/05

Mixing pumps are often used in the current construction of new rural areas. They can not only perform on-site mixing, but also transport concrete. It is suitable for reservoir construction, residential building construction, tunnel engineering, and water conservancy engineering construction projects. Many people are very concerned about the operating conditions of concrete pumps when they are in use, but few people pay attention to the correct way
Mixing pumps are often used in the current construction of new rural areas. They can not only perform on-site mixing, but also transport concrete. It is suitable for reservoir construction, residential building construction, tunnel engineering, and water conservancy engineering construction projects. Many people are very concerned about the operating conditions of concrete pumps when they are in use, but few people pay attention to the correct way to store concrete pumps when they are idle. In fact, paying attention to this can avoid problems during construction. So how to properly store the concrete mixing pump when it is idle? How to properly store the concrete mixing pump when it is idle! It can be done from the following aspects:

1. After the concrete mixing pump is idle, it should generally be parked in a dry room. Those who have to park outdoors should choose a flat ground and cover it with wooden boards.

2. After the concrete mixing pump is parked, cover it with a cover cloth. Before long-term storage, the machinery must be maintained, repaired to damaged parts, and thoroughly cleaned to keep it in good technical condition.

3. The arrangement and arrangement of the mixing pumps in the parking lot should ensure that the entry and exit of any machine are not affected by other concrete pump machines.

4. The fuel control lever of the concrete mixer pump machine should be placed in the idle position, and each lever should be placed in the neutral position.